Xmk-010 Manual [portable] Jun 2026

Leave the buttons untouched for 5 seconds. The controller will save your new values to its internal memory and return to the live temperature read-out. Parameter Menu Table Parameter Code Description Factory Default Adjustable Range F1 Upper Temperature Limit (Compressor On / Heater Off) Lower Limit to +50°C F2 Lower Temperature Limit (Compressor Off / Heater On) -50°C to Upper Limit F3 Compressor Delay Protection Timer 0 to 9 Minutes F4 Temperature Calibration Adjustment -5°C to +5°C Maintenance and Troubleshooting

If you set the , the XMK-010 will automatically adjust the Upper Limit to be Lower Limit + 1°C to ensure logical operation.

Check if bare wires are touching. Replace the damaged NTC probe. Power failure or dead control transformer. xmk-010 manual

Fix: Verify that 220V AC is present across terminals 3 and 4.

Check probe connection lines for tears, cuts, or loose terminal screws. Short-circuit in the temperature probe loop. Leave the buttons untouched for 5 seconds

Use the control panel buttons to define the high-temperature (stop) and low-temperature (start) thresholds.

Built-in alerts for temperature sensor issues, such as open-loop or short circuits. Basic Programming Guide Check if bare wires are touching

The back of the XMK-010 features a terminal block for power supply, sensor inputs, and load switching. Wire the unit using the following standard layout:

The faceplate of the XMK-010 features a dual-line or split digital display alongside control keys: