Tgc Bc-90-1h Manual New! -

Turn the controller back on and cycle the shower tap open and closed several times, waiting 10 seconds between each cycle to clear air pockets out of the line. Code 63: Recirculation Error

: Sub-tropical (designed to run efficiently in ambient room temperatures up to 38°C / 100°F). Refrigerant : R600a (Hydrocarbon, eco-friendly refrigerant).

: When one controller holds priority, the priority lights on all other connected panels will blink or stay dark, meaning their temperature buttons are deactivated.

– System supports up to 2 bathroom remote controllers (including BC-90-1H and BC-90Q-1H) plus 1 kitchen remote controller (MC-90-1H). tgc bc-90-1h manual

Under Hong Kong Gas Safety Regulations, all installations and repairs must be performed by a registered gas installer .

A: No. If the battery is already full, the charger is in Float mode. Try connecting a known dead battery. If the amperage stays at 0, check the fuses.

Press the "Priority" button if the light is not already on. You cannot change settings while someone else has priority or while the heater is currently running. Turn the controller back on and cycle the

Safety is the primary feature of the BC-90-1H manual operation:

– Use the temperature adjustment buttons to raise or lower the hot water temperature. The temperature is shown on the display in degrees Celsius.

Here are the standout features and operational insights you need to know. : When one controller holds priority, the priority

Perhaps the most critical function of the manual is its focus on safety. Industrial equipment like the BC-90-1H often involves high-voltage electrical components, pressurized systems, or specific ventilation requirements. The manual outlines "best practices" and warning signs that are crucial for preventing workplace accidents. By standardizing the handling procedures, the documentation minimizes human error—the leading cause of equipment failure and safety breaches. Troubleshooting and Maintenance

Press the "On/Off" button; the digital display will light up.

Based on the official documentation, here is how to use the remote: