Manual: Sinotimer Tm630s

Hold down the CLOCK button and press the H+ button until the current hour is displayed.

Press until the correct day of the week appears at the top of the screen. Press H+ to set the current hour. Press M+ to set the current minute. Release the 🕒 (Clock) button.

Connect the device to its rated power supply for at least 10 minutes to charge the battery. If it remains blank, use a pin to press the RESET button. The timer clicks, but the appliance does not turn on

Press the small C button with a pin to clear all settings and start fresh. ❓ Troubleshooting Tips sinotimer tm630s manual

The TM630S must be wired to a power source and the load it is controlling.

Enters current time mode / exits programming mode.

| Button | Function | |--------|----------------------------------| | | Enter/exit menu, confirm setting | | ▲ | Increase value / change mode | | ▼ | Decrease value | | RST | Reset timer / stop output | Hold down the CLOCK button and press the

While holding the button, press H+ to adjust the current hour (uses a 24-hour clock format).

For standard scheduled operations, ensure your screen reads after making a selection. Troubleshooting Common Issues The screen is locked and buttons are unresponsive

Verify that you have not overlapping settings (e.g., Program 1 ON and Program 2 OFF causing conflicts). Press M+ to set the current minute

Press to match the exact day block you chose for the "1 ON" step.

The button overrides your automated programs. Pressing it cycles through three states:

Do you need a (Cycle timer) or just a daily ON/OFF? Is your unit the 110V or 220V version?

If the screen is blank when you unbox the device, connect it to a power source for 5 minutes to charge the internal battery, then press the recessed button with a pin. To set the current time and day:

The button cycles through four distinct modes shown at the bottom of the screen. This determines how the timer behaves relative to its programming: