Rok Power Washer Instructions ((better)) Today

Turn the power switch to the or 0 position (or turn off the petrol engine switch). Shut off the household water tap completely.

This guide provides step-by-step instructions for assembling, starting, using, and maintaining your ROK power washer. Table of Contents Safety Precautions Unpacking and Assembly Setup and Water Connection Starting Your ROK Power Washer Using the Pressure Washer (Operation) Using Detergents Shutdown Procedure Troubleshooting Common Issues 1. Safety Precautions

Extension cords can cause voltage drops, overheating, and motor burnout. 2. Step-by-Step Setup Guide rok power washer instructions

| Problem | Likely Cause | Solution | |--------|--------------|----------| | No pressure | Pump not primed | Fill intake line – squeeze trigger & pump slowly until water flows | | Pulsing spray | Air in system | Continue pumping with trigger open until stream is steady | | Hard to pump | Nozzle clogged or on zero spray | Remove nozzle, flush with clean water, or switch to wider pattern | | Water leaks from pedal | Worn seals (normal after heavy use) | Rebuild kit available from ROK | | Won’t draw water | Intake hose cracked or bucket too low | Keep intake submerged; hose must be air‑tight |

Switch back to a high-pressure nozzle (such as the 25-degree or 40-degree tip) and rinse the soap away working from the top down. 6. Shutdown and Storage Procedures Turn the power switch to the or 0

Ensure the low-pressure black nozzle is fully snapped into the wand end. Worn O-rings

Always start spraying from at least 30 to 50 cm away from the surface. Move closer only if needed, monitoring the surface closely for signs of damage. 4. How to Apply Detergents Table of Contents Safety Precautions Unpacking and Assembly

Switch your nozzle to the low-pressure setting (usually a black nozzle or by pulling the adjustable lance tip outward). Soap will not draw if the machine is operating at high pressure.

Insert the power plug into a GFCI outlet. Press the Reset button on the plug module to ensure power is flowing.