Magic Pass 4300 User Manual «TRENDING»

Place the registered finger on the sensor. The device will authenticate within one second. Fingerprint Quality Display: The Magic Pass 4300 Go to product viewer dialog for this item.

: Lock Drive Output (Relay 3A), Alarm Output (Relay 1A) Important Environmental and Handling Precautions

Set : Assign a static local IP matching your subnet (e.g., 192.168.1.201 ). magic pass 4300 user manual

High-intensity ambient light destabilizes optical fingerprint sensors and causes recurring verification failures.

(standard), RS232, or Wiegand to integrate with your existing door locks and networks. 🛠 Troubleshooting Tip Place the registered finger on the sensor

Press the Menu button. You may be required to scan an authorized administrator's fingerprint.

[ Magic Pass 4300 Back Panel ] │ ┌────────────────┴────────────────┐ ▼ ▼ [ Power Input ] [ Access Control ] └─ 12V DC (+) ├── NO (Normally Open) └─ GND (-) ├── NC (Normally Closed) ├── COM (Common) └── Exit Button / Sensor Step-by-Step Mounting : Lock Drive Output (Relay 3A), Alarm Output

Pull the power, network, and lock control wires through the center hole of the backplate.

Input a unique (e.g., 192.168.1.201 ) that matches your local network subnet. Set the Subnet Mask (typically 255.255.255.0 ) and Gateway .