The best way to handle a blobby boi is to keep your nozzle tight, your bed clean, and your printer maintained. But if it happens, heat, peel, and reprint!
Turn on your printer and heat the nozzle to the printing temperature of the material that made the blob (typically 220--250°C for PLA/PETG). Let it sit at this temperature for 5-10 minutes to allow the heat to soften the plastic from the inside out. ext printer blobby boi
Always tighten your nozzle at high temperatures (~240°C) to ensure a proper seal with the heat break [1]. The best way to handle a blobby boi
Has anyone seen this guy? 🧐
Look closely at the back of the heater block. Identify where the red heater cartridge wires and the thin thermistor wires enter the block. Let it sit at this temperature for 5-10
It is the ultimate nightmare for any 3D printing enthusiast. You start a long print, walk away for a few hours, and return to find your printer nozzle completely encased in a massive, molten plastic tumor. In the 3D printing community, this catastrophic failure is affectionately—and sometimes fearfully—known as the or the "Blob of Doom."